HEIDENHAIN IK 5293 - Manual (Page 307)

293
Chapter 7
Programming
The QC5000 is user programmable. Users can enter a series of steps and
save it as a program for later use. When the program is executed the QC5000
prompts the user to perform the necessary steps for the inspection of the
part. This function is useful for repetitive measuring of large quantities of
parts. QC5000 programs are part specific, that is each program is for a
specific part. A sample program and instructions to create it are included in
this chapter.
Programming Overview
The QC5000 programming feature works like a tape recorder. The follow-
ing sections explain programming features and demonstrate how to create,
save, and run a program. To avoid confusion, use the QC5000 demo part for
the following sections. Any multi-feature part may be substituted in later
programs.
Keep in mind that QC5000 programs execute sequentially. If a step refer-
ences a feature, that feature must already be measured. Here are two simple
tips for hassle free programming:
•
Only reference features that have been measured prior to the step that
references them.
•
Do not delete a features that are part of a construction.
NOTE NOTE NOTE NOTE NOTE
In this section all instructions refer to the program toolbar In this section all instructions refer to the program toolbar In this section all instructions refer to the program toolbar In this section all instructions refer to the program toolbar In this section all instructions refer to the program toolbar.....
The same procedures can be performed using the pull down
The same procedures can be performed using the pull down The same procedures can be performed using the pull down The same procedures can be performed using the pull down The same procedures can be performed using the pull down
menus at the top of the screen as well.
menus at the top of the screen as well. menus at the top of the screen as well. menus at the top of the screen as well. menus at the top of the screen as well.
NOTE NOTE NOTE NOTE NOTE
T TT T Toolbars in the QC5000 software can be customized. This manual oolbars in the QC5000 software can be customized. This manual oolbars in the QC5000 software can be customized. This manual oolbars in the QC5000 software can be customized. This manual oolbars in the QC5000 software can be customized. This manual
attempts to display the most common toolbar arrangements. attempts to display the most common toolbar arrangements. attempts to display the most common toolbar arrangements. attempts to display the most common toolbar arrangements. attempts to display the most common toolbar arrangements.
Some users may find the toolbar setup on their system varies
Some users may find the toolbar setup on their system varies Some users may find the toolbar setup on their system varies Some users may find the toolbar setup on their system varies Some users may find the toolbar setup on their system varies
from those shown here.
from those shown here. from those shown here. from those shown here. from those shown here.