HEIDENHAIN TNC 640 (34059x-04) Cycle programming - Manual (Page 602)

Index
602
TNC 640 | User's Manual Cycle Programming | 3/2014
Side finishing............................ 193
Single-lip deep-hole drilling......... 95
SL Cycles......................... 178, 209
Contour cycle......................... 180
Contour data.......................... 185
Contour train.......................... 195
Floor finishing......................... 192
SL cycles
Fundamentals......................... 178
Fundamentals......................... 232
SL Cycles
Pilot drilling............................ 187
Roughing................................ 189
Side finishing.......................... 193
Superimposed contours. 181, 226
SL cycles with complex contour
formula..................................... 222
SL cycles with simple contour
formula..................................... 232
Slot milling
Roughing+finishing................ 147
Spindle orientation................... 286
T
Tapping
With a floating tap holder....... 103
With chip breaking................. 109
Without a floating tap
holder............................. 106, 109
Thread drilling/milling............... 123
Thread milling/countersinking... 119
Tilting function
Procedure............................... 278
Tilting the working plane.. 273, 273
Cycle...................................... 273
Tolerance monitoring................ 493
Tool compensation................... 494
Tool measurement........... 580, 584
Calibrate TT.................... 586, 587
Machine parameters.............. 582
Measuring tool length and
radius..................................... 592
Tool length............................. 588
Tool radius.............................. 590
Tool monitoring........................ 494
Touch probe cycles
For automatic mode............... 406
Touch probe data...................... 412
Touch probe table..................... 411
Turning cycles.................. 294, 307
Axial recessing....
358,
365, 380, 386
Contour face.......................... 343
Contour longitudinal............... 321
Contour-parallel....................... 325
Radial recessing............. 347, 369
Recessing, axial extended.... 361,
382
Recessing, radial extended....
350,
372
Recessing contour, radial.... 354,
376
shoulder, longitudinal extended....
310
Shoulder face......................... 329
Shoulder face extended......... 332
Shoulder longitudinal.............. 308
Thread, contour-parallel.......... 396
Thread, extended................... 392
Thread, longitudinal................ 389
Transverse plunge.................. 336
Transverse plunge extended.. 339
Turn, longitudinal plunge......... 314
Turn, longitudinal plunge
extended................................ 317
U
Universal drilling................... 82, 88
W
Workpiece Measurement......... 490