HEIDENHAIN TNC 640 (34059x-04) Cycle programming - Manual (Page 524)

Touch Probe Cycles: Automatic Workpiece Inspection
17.12 MEASURE BOLT HOLE CIRCLE (Cycle 430, DIN/ISO: G430)
17
524
TNC 640 | User's Manual Cycle Programming | 3/2014
Measuring log Q281: Define whether the TNC
should create a measuring log:
0 : Do not create a measuring log
1
: Create a measuring log: The TNC saves the
log
file TCHPR430.TXT as standard in the directory
TNC:\.
2 : Interrupt program run and output measuring log
to the TNC screen. Resume program run with NC
Start.
PGM stop if tolerance error Q309: Definition of
whether in the event of a violation of tolerance
limits the TNC is to interrupt program run and output
an error message:
0 : Do not interrupt program run, do not output an
error message
1 : Interrupt program run and output an error
message
Tool number for monitoring Q330: Definition of
whether the TNC is to monitor for tool breakage
(see "Tool monitoring", page 494). Input range 0 to
32767.9, alternatively tool name with maximum of
16 characters.
0 : Monitoring inactive
> 0 : Tool number in the tool table TOOL.T
Q309=0 ;PGM STOP IF ERROR
Q330=0 ;TOOL