HEIDENHAIN TNC 620 (81760x-02) Cycle programming - Manual (Page 45)

Available Cycle Groups 1.2
1
TNC 620 | User's Manual Cycle Programming | 2/2015
45
1.2 Available Cycle Groups
Overview of fixed cycles
The soft-key row shows the available groups of
cycles
Cycle group Soft key Page
Cycles for pecking, reaming, boring and counterboring 68
Cycles for tapping, thread cutting and thread milling 98
Cycles for milling pockets, studs and slots and for face milling 134
Coordinate transformation cycles which enable datum shift, rotation, mirror image,
enlarging and reducing for various contours 248
Subcontour List (SL) cycles, which allow the machining of contours consisting of
several overlapping subcontours, as well as cycles for cylinder surface machining
and for trochoidal milling 216
Cycles for producing point patterns, such as circular or linear hole patterns 172
Special cycles such as dwell time, program call, oriented spindle stop, engraving,
tolerance, ascertaining the load 272
If required, switch to machine-specific fixed
cycles. These fixed cycles can be integrated by
your machine tool builder.