HEIDENHAIN TNC 620 (81760x-02) Cycle programming User Manual
Page 19
TNC 620 | User's Manual Cycle Programming | 2/2015
19
4
Fixed Cycles: Tapping / Thread Milling........................................................................................ 97
4.1
Fundamentals........................................................................................................................................ 98
Overview................................................................................................................................................. 98
4.2
TAPPING with a floating tap holder (Cycle 206, DIN/ISO: G206).....................................................99
Cycle run................................................................................................................................................. 99
Please note while programming:.......................................................................................................... 100
Cycle parameters.................................................................................................................................. 101
4.3
RIGID TAPPING without a floating tap holder (Cycle 207, DIN/ISO: G207)................................... 102
Cycle run............................................................................................................................................... 102
Please note while programming:.......................................................................................................... 103
Cycle parameters.................................................................................................................................. 104
Retracting after a program interruption................................................................................................ 104
4.4
TAPPING WITH CHIP BREAKING (Cycle 209, DIN/ISO: G209, software option 19)....................... 105
Cycle run............................................................................................................................................... 105
Please note while programming:.......................................................................................................... 106
Cycle parameters.................................................................................................................................. 107
4.5
Fundamentals of Thread Milling....................................................................................................... 109
Prerequisites..........................................................................................................................................109
4.6
THREAD MILLING (Cycle 262, DIN/ISO: G262, software option 19)...............................................111
Cycle run............................................................................................................................................... 111
Please note while programming:.......................................................................................................... 112
Cycle parameters.................................................................................................................................. 113
4.7
THREAD MILLING/COUNTERSINKING (Cycle 263, DIN/ISO:G263, software option 19).............. 114
Cycle run............................................................................................................................................... 114
Please note while programming:.......................................................................................................... 115
Cycle parameters.................................................................................................................................. 116
4.8
THREAD DRILLING/MILLING (Cycle 264, DIN/ISO: G264, software option 19).............................118
Cycle run............................................................................................................................................... 118
Please note while programming:.......................................................................................................... 119
Cycle parameters.................................................................................................................................. 120