HEIDENHAIN TNC 620 (81760x-02) Cycle programming User Manual

Page 24

Contents

TNC 620 | User's Manual Cycle Programming | 2/2015

Fixed Cycles: Contour Pocket......................................................................................................181

7.1

SL Cycles.............................................................................................................................................. 182

Fundamentals........................................................................................................................................ 182

Overview............................................................................................................................................... 183

7.2

CONTOUR (Cycle 14, DIN/ISO: G37)................................................................................................. 184

Please note while programming:.......................................................................................................... 184

Cycle parameters.................................................................................................................................. 184

7.3

Superimposed contours..................................................................................................................... 185

Fundamentals........................................................................................................................................ 185

Subprograms: overlapping pockets....................................................................................................... 185

Area of inclusion................................................................................................................................... 186

Area of exclusion.................................................................................................................................. 187

Area of intersection.............................................................................................................................. 188

7.4

CONTOUR DATA (Cycle 20, DIN/ISO: G120, software option 19)...................................................189

Please note while programming:.......................................................................................................... 189

Cycle parameters.................................................................................................................................. 190

7.5

PILOT DRILLING (Cycle 21, DIN/ISO: G121, software option 19)................................................... 191

Cycle run............................................................................................................................................... 191

Please note while programming:.......................................................................................................... 192

Cycle parameters.................................................................................................................................. 192

7.6

ROUGHING (Cycle 22, DIN/ISO: G122, software option 19)........................................................... 193

Cycle run............................................................................................................................................... 193

Please note while programming:.......................................................................................................... 194

Cycle parameters.................................................................................................................................. 195

7.7

FLOOR FINISHING (Cycle 23, DIN/ISO: G123, software option 19)................................................197

Cycle run............................................................................................................................................... 197

Please note while programming:.......................................................................................................... 197

Cycle parameters.................................................................................................................................. 198

7.8

SIDE FINISHING (Cycle 24, DIN/ISO: G124, software option 19)................................................... 199

Cycle run............................................................................................................................................... 199

Please note while programming:.......................................................................................................... 200

Cycle parameters.................................................................................................................................. 201