HEIDENHAIN TNC 620 (81760x-02) Cycle programming User Manual

Page 34

Contents

TNC 620 | User's Manual Cycle Programming | 2/2015

14 Touch Probe Cycles: Automatic Datum Setting........................................................................ 323

14.1 Fundamentals...................................................................................................................................... 324

Overview............................................................................................................................................... 324

Characteristics common to all touch probe cycles for datum setting...................................................326

14.2 DATUM SLOT CENTER (Cycle 408, DIN/ISO: G408, software option 17)....................................... 328

Cycle run............................................................................................................................................... 328

Please note while programming:.......................................................................................................... 329

Cycle parameters.................................................................................................................................. 330

14.3 DATUM RIDGE CENTER (Cycle 409, DIN/ISO: G409, software option 17)..................................... 332

Cycle run............................................................................................................................................... 332

Please note while programming:.......................................................................................................... 332

Cycle parameters.................................................................................................................................. 333

14.4 DATUM FROM INSIDE OF RECTANGLE (Cycle 410, DIN/ISO: G410, software option 17).............335

Cycle run............................................................................................................................................... 335

Please note while programming:.......................................................................................................... 336

Cycle parameters.................................................................................................................................. 337

14.5 DATUM FROM OUTSIDE OF RECTANGLE (Cycle 411, DIN/ISO: G411, software option 17)......... 339

Cycle run............................................................................................................................................... 339

Please note while programming:.......................................................................................................... 339

Cycle parameters.................................................................................................................................. 340

14.6 DATUM FROM INSIDE OF CIRCLE (Cycle 412, DIN/ISO: G412, software option 17).....................342

Cycle run............................................................................................................................................... 342

Please note while programming:.......................................................................................................... 343

Cycle parameters.................................................................................................................................. 344

14.7 DATUM FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413, software option 17)................. 347

Cycle run............................................................................................................................................... 347

Please note while programming:.......................................................................................................... 347

Cycle parameters.................................................................................................................................. 348

14.8 DATUM FROM OUTSIDE OF CORNER (Cycle 414, DIN/ISO: G414, software option 17).............. 351

Cycle run............................................................................................................................................... 351

Please note while programming:.......................................................................................................... 352

Cycle parameters.................................................................................................................................. 353