HEIDENHAIN TNC 620 (81760x-02) Cycle programming - Manual (Page 258)

Cycles: Coordinate Transformations
10.6 ROTATION (Cycle 10, DIN/ISO: G73)
10
258
TNC 620 | User's Manual Cycle Programming | 2/2015
10.6 ROTATION (Cycle 10, DIN/ISO: G73)
Effect
The TNC can rotate the coordinate system about the active datum
in the working plane within a program.
The ROTATION cycle becomes effective as soon as it is defined in
the program. It is also effective in the Positioning with MDI mode
of operation. The active rotation angle is shown in the additional
status display.
Reference axis for the rotation angle:
X/Y plane: X axis
Y/Z plane: Y axis
Z/X plane: Z axis
Resetting
Program the ROTATION cycle once again with a rotation angle of
0°.