beautypg.com

6 workpiece setup, Select the correct operating mode, Clamp the workpiece – HEIDENHAIN TNC 620 (340 56x-02) User Manual

Page 53: 6 w o rkpiece set u p 1.6 workpiece setup

background image

HEIDENHAIN TNC 620

53

1

.6 W

o

rkpiece Set

u

p

1.6 Workpiece Setup

Select the correct operating mode

Workpieces are set up in the Manual Operation or Electronic
Handwheel

mode

U

Press the operating modes key: The TNC goes into

the Manual Operation mode

Further information on this topic

„

Manual mode: See “Moving the Machine Axes” on page 365

Clamp the workpiece

Mount the workpiece with a fixture on the machine table. If you have
a 3-D touch probe on your machine, then you do not need to clamp the
workpiece parallel to the axes.

If you do not have a 3-D touch probe available, you have to align the
workpiece so that it is fixed with its edges parallel to the machine
axes.

See also other documents in the category HEIDENHAIN Equipment: