HEIDENHAIN TNC 620 (340 56x-02) - Manual (Page 410)

410 Test Run and Program Run
14.1 Gr
aphics (A
dv
anced Gr
aphic F
e
at
ur
es Sof
tw
a
re
Option)
Magnifying details
You can magnify details in all display modes in the Test Run mode and
a Program Run mode.
The graphic simulation or the program run, respectively, must first
have been stopped. A detail magnification is always effective in all
display modes.
Changing the detail magnification
The soft keys are listed in the table
U Interrupt the graphic simulation, if necessary
U Shift the soft-key row in the Test Run mode, or in a Program Run
mode, respectively, until the soft key for detail enlargement appears
U Shift the soft-key row until the soft-key for the detail
magnification functions appears
U Select the functions for detail magnification
U Press the corresponding soft key to select the
workpiece surface (see table below)
U To reduce or magnify the blank form, press and hold
the MINUS or PLUS soft key, respectively
U Restart the test run or program run by pressing the
START soft key (RESET + START returns the
workpiece blank to its original state)
Function Soft keys
Select the left/right workpiece surface
Select the front/back workpiece surface
Select the top/bottom workpiece surface
Shift the sectional plane to reduce or
magnify the blank form
Select the isolated detail
After a new workpiece detail magnification is selected, the
control “forgets” previously simulated machining
operations. The TNC then displays machined areas as
unmachined areas.
The TNC displays the selected workpiece side for each
axis and the coordinates of the remaining form during a
detail magnification.