HEIDENHAIN TNC 620 (340 56x-02) - Manual (Page 28)

28
12.1 Switch-On, Switch-Off ..... 362
Switch-on ..... 362
Switch-off ..... 364
12.2 Moving the Machine Axes ..... 365
Note ..... 365
To traverse with the machine axis direction buttons: ..... 365
Incremental jog positioning ..... 366
Traversing with the HR 410 electronic handwheel ..... 367
12.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 368
Function ..... 368
Entering values ..... 368
Changing the spindle speed and feed rate ..... 369
12.4 Datum Setting without a 3-D Touch Probe ..... 370
Note ..... 370
Preparation ..... 370
Workpiece presetting with axis keys ..... 371
Datum management with the preset table ..... 372
12.5 Using 3-D Touch Probes (Touch Probe Function Software Option) ..... 378
Overview ..... 378
Selecting probe cycles ..... 379
Writing the measured values from touch probe cycles in datum tables ..... 380
Writing the measured values from touch probe cycles in the preset table ..... 381
12.6 Calibrating 3-D Touch Probes (Touch Probe Function Software Option) ..... 382
Introduction ..... 382
Calibrating the effective length ..... 382
Calibrating the effective radius and compensating center misalignment ..... 383
Displaying calibration values ..... 384
12.7 Compensating Workpiece Misalignment with 3-D Touch Probe (Touch Probe Function Software Option) ..... 385
Introduction ..... 385
Measuring the basic rotation ..... 385
Saving the basic rotation in the preset table ..... 386
Displaying a basic rotation ..... 386
Canceling a basic rotation ..... 386
12 Manual Operation and Setup ..... 361