HEIDENHAIN TNC 620 (340 56x-02) - Manual (Page 492)

492
Compar
ison: F
unctions of the TNC 620 and the iTNC
530
Comparison: Touch probe cycles in the Manual
Operation and El. Handwheel modes
Cycle TNC 620 iTNC 530
Touch-probe table for managing 3-D touch probes X –
Calibrating the effective length Option #17 X
Calibrating the effective radius Option #17 X
Measuring a basic rotation using a line Option #17 X
Datum setting in any axis Option #17 X
Setting a corner as datum Option #17 X
Setting a circle center as datum Option #17 X
Setting a center line as datum – X
Measuring a basic rotation using two holes/cylindrical studs – X
Setting the datum using four holes/cylindrical studs – X
Setting the circle center using three holes/cylindrical studs – X
Support of mechanical touch probes by manually capturing the current position By soft key By hard key
Writing measured values in preset table X X
Writing measured values in datum tables X X