HEIDENHAIN ND 281 B v.2 - Manual (Page 11)

11
Finding Minimum and Maximum Values
Starting a series of measurements
Select the display for a series of meas-
urements.
The selected indicator starts blinking
(here, MAX).
Confirm selection.
Repeatedly
MOD
... until the START indicator starts blinking.
MOD
Repeatedly
Switching between MIN, MAX, DIFF and ACTL displays
It is not possible to switch between the displays as
described below if the switching input for external
control of the series of measurements (pin 6 on
D-sub connection EXT) is active.
As an alternative, you can select the display with operating
parameter P21 (see "Operating Parameters").
Select the new display of a series of
measurements.
The selected indicator starts blinking
(here, MIN).
Confirm the change.
Repeatedly
MOD
The display now shows the smallest value measured during the
current series of measurements.
Indicator preselection
Press MOD to start the series of measurements and select
the display with the indicators.
Operating parameter P86 allows you to define which indicator
is displayed first when MOD is pressed.
Start the series of measurements.
MAX
START
MIN