Grass Valley RSE1 - Manual (Page 12)

RSE 1 Stand-Alone Controller
7 Rev. 1 / 02.2002
3. INSTALLATION
3.1 SAFETY INSTRUCTIONS
Caution!
These instructions are for use by qualified personnel only. To reduce the risk
of electric shock, do not perform any installation other than that contained
in the Operating Instructions unless you are qualified to do so. Refer all servi-
cing to qualified service personnel.
Attention!
Electrostatic sensitive devices on the p. c. boards. Observe the following
precaution for handling:
D
Handling or mounting the RSE1 unit call for special attention to personal safety.
Personnel should be connected to ground potential via a wristlet (e.g. 3M Wrist-
let Serial 2200).
D
Do not touch the p. c. boards during mounting.
D
Repair the p. c. boards only at static-safe work stations.
D
Use antistatical protective bags when carrying the p.c. boards.
Attention!
Danger of explosion when the battery is not correctly inserted. Replace the
battery only by a battery from the same manufacturer or by an equivalent
type recommended by the manufacturer.
Protect the environment!
Dead batteries do not belong in the garbage. Hand the used batteries over
to a local disposal place or observe the respective instructions of the
manufacturer!