Grass Valley RSE1 User Manual

Page 36

RSE 1

Stand-Alone Controller

Rev. 1 / 02.2002

6.2

LOADING DEFAULT MACROS FROM THE SIDEPANEL

After creating an appli_cp.ini file in the application you must load a default macro
(see chapter 6.3 List of default Macros) into the appli_cp.ini file. This is necessary
to have the default macro available after every restart of the RSAT panel.

1. Open the appli_cp.ini file of the RSE1 folder (e.g. CP9) and go to the end of

the file to [SATPANEL1].

2. Enter the name of your preferred macro into the filename, as it is shown in the

picture below. Do not forget to add the extension .sat and note that the macro
names are case sensitive (use only small letters).

Example of the appli_cp.ini file:

3. After that save the appli_cp.ini file and reload the running application of the

sidepanel. The entered macro will be loaded to the connected RSAT panel.

Notes:

With a RSAT panel connected to a RSE1 you cannot learn single buttons
like with a RSAT panel connected directly to the sidepanel.

Whenever you change the default macro you have to reload the applica-
tion.