Grass Valley Maestro Master Control Branding Engine v.1.6.0 - Manual (Page 75)

Maestro — Branding Engine Quick Start Guide 75
Verify Branding Element Assignment
Verify Branding Element Assignment
To verify that deployed branding content can be assigned properly to video
keyers or audio over mixers, do the following:
1. On a control panel Source Assignment panel (hardware or GUI) press
the
Send button.
2. Select the category button to which a still image or audio mix over
branding source has been assigned.
3. Enter the source number that designates the desired source.
Note As an example, in Figure 43 on page 68 , “SMPTE Bars” is source number 11
in the Logo category.
4. Press any PST button on the Keyer or Audio panel (depending on the
source type you wish to assign) that is illuminated in green to assign the
selected source to that button.
The specified mnemonic for the selected source appears in the PGM LCD
button.
5. Press the appropriate PST button to activate the source on the PST
monitor.
6. Verify the presence of a still image source on the PST monitor or the
presence of an audio over source by selecting the appropriate audio
over mixer as the monitor point in the Audio sub-panel.