Grass Valley Maestro Master Control Branding Engine v.1.6.0 User Manual

Page 30

Maestro — Branding Engine Quick Start Guide

Section 1 — Software Installation

The Configuration box contains two buttons:

Update Only

and

Update and

Apply

•

Update Only

- Downloads the selected configuration file to the

boards, but, does not apply it as the running configuration. The
selected configuration files appears in the “Pending>>” row.
The currently active configuration appears in the “Running>>”
rows.

•

Update & Apply

- Downloads the selected configuration file to the

boards and applies it as the running configuration.

Click the

Update Only

button.

This action will update the contents of the “Pending>>” row in the
Board Configuration and Active Configuration columns. See

Figure 8

Note

When the Update Only button is clicked, the configuration file does not
become the active configuration until the Apply Pending button is clicked to
activate the “pending” configuration.

CAUTION The following step will interrupt the video and audio signals passing through

the system for about 1 minute.

In the Software Application box:

The “Folder” field should indicate “C:\MaestroEmbedded.”

In the Frame Processor Tar File Name

field:

--For LTC systems (those using Linear Time Code) select
“MaestroMC_1.600.3353.1054.LTC.tar.” (When used, LTC is con-
nected to pins 43 and 44 of the GPIO connector on the rear panel.)

--For VITC systems (those using Vertical Interval Time Code) select
“MaestroMC_1.600.3353.1054.VITC.tar.”

In the Control Panel Tar File Name, field, select
“MaestroCP_1.600.3353.1054.tar.”

Click the

Select All

button (lower right corner of menu).

Alternatively, each board can be updated independently by clicking on
the "Board Name" field or all at the same time by using the "Select All"
button.