Grass Valley Maestro Master Control Branding Engine v.1.6.0 - Manual (Page 47)

Maestro — Branding Engine Quick Start Guide 47
Branding Engine Hard Drive(s) Installation
Note The drive sled face plate is positioned at the closed end of the drive. Make
sure the drive connectors at the back of the drive are not covered.
3. With the included screws, attach the drive sled to the disk drive.
The drive mounting sled properly attached to a disk drive is illustrated in
Figure 24
Figure 24. Mounting Sled Attached to Disk Drive
4. Insert the mounting sled and drive assembly into the desired slot in the
disk drive cage on the Maestro Processor board. Push gently to make
sure the drive connector and interface board connectors at the rear of
the drive cage are well connected.
Note If installing only one drive, it should be installed in the lower left slot (ata0).
5. Tighten the mounting screw on the sled to securely hold the disk drive
in the drive cage.
Figure 25 shows the drive assembly installed in the drive cage on the
Maestro Processor board.