Grass Valley Maestro Master Control Branding Engine v.1.6.0 - Manual (Page 28)

28 Maestro — Branding Engine Quick Start Guide
Section 1 — Software Installation
Re-compiling the Configuration File
It is required that all configuration sets to be used with Maestro software
version 1.6.0 be recompiled with the 1.6.0 Configuration Editor. This will
add the following:
• The Content Definition table.
• The Content Input table.
• The VBI Passthrough table.
• The Clean Feed 1 and Clean Feed 2 configuration columns in the
Channel Setup table.
• The Channel Delegation Subpanel Configuration Set column in the
Channel Server table.
Note The Channel Delegation Subpanel table has changed and may require recon-
figuration.
Recompiling is also required if performing a software update when the
prior software was v1.3 or older. Changes have been made to the structure
of the Monitor Follow configuration table.
1. Launch the Maestro Configuration Editor by going to “Start > All
Programs > Thomson > Maestro Configuration Editor.”
2. Select the Maestro configuration set to be re-compiled by going to “File
> Open > Thomson” and selecting the set.
This should be the configuration set created for v1.6.0 use ( Step d on
page 23 ).
3. If the system displays a Validation Report, you must check the
indicated table(s) and make corrections as indicated.
You can use the links in the Description column to display the table(s).
4. Save the configuration file.
5. Compile the file by going to “File > Compile Channel Data.”
6. Proceed to Updating the System Configuration and Software below.