Grass Valley M-2100 - Manual (Page 60)

2-36 MMCP Installation/Operation Manual
Section 2 — System Operations
You can store up to four SqueezeBack/Crop effects. The four effects (num-
bered 1, 2, 3, and 4) are defined in Configuration Manager and are select-
able on the Keyer Control subpanel on the MMCP (
Figure 2-11 on
page 2-24 ).
Factory Built SqueezeBack Effects
There are four factory-initialized SqueezeBack effects that you may select
or they may be configured to suit your own needs. The factory settings are:
■ SqueezeBack Effect #1: squeeze to upper left,
■ SqueezeBack Effect #2: squeeze to upper right,
■ SqueezeBack Effect #3: squeeze to lower left, and
■ SqueezeBack Effect #4: squeeze to lower right.
Viewing the Current SqueezeBack Effect
The current SqueezeBack effect can be viewed on the LAP monitor under
any one of following three conditions:
■ SqueezeBack is not on-air and the next transition will take it to air.
SqueezeBack must be selected and active and not on-air. That is, Squee-
zeBack tallies high and
SQB status tallies off.
■ SqueezeBack is on-air and the next transition will not take it off air.
SqueezeBack must be selected and not active and on-air — that is,
SqueezeBack tallies low.
■ A SqueezeBack effect selection has been made.