Grass Valley M-2100 - Manual (Page 29)

MMCP Installation/Operation Manual 2-5
Using Multichannel Control
2. Press and hold down one unassigned Channel Control button whose
button state is off.
3. Release the Mode/Function button. Continue to hold down the Channel
Control button.
4. Use the first two buttons, Take and Fade/Fade , in the Transition Type
subpanel to scroll through the list of available valid channel names
displayed in the Source Name display corresponding to the selected
Channel Control button ( Figure 2-3 on page 2-4 ).
Note Frame names already assigned will not appear in the list.
5. When the desired FCM name is found, and while continuing to hold
the
Channel Control button, press and release the Mode/Function button.
6. Release the Channel Control button. The FCM name is assigned to the
associated Channel Control button and the button will light dim green to
indicate it is assigned and connected or dim red if it is assigned but not
available. Refer to
Table 2-1 on page 2-4 for a summary of other status
states.
7. To delete an assignment, scroll through the list and assign None to the
button.
In addition to the above functionality, an assigned and connected (dim
green status) channel may be released to allow another control panel to
acquire it without changing the assigned FCM name stored in non-volatile
memory.
To release a channel for use by another MCP, do the following:
1. Press and hold the Mode/Function button.
2. Press and hold the appropriate Channel Control button.
3. Release the Mode/Function button and momentarily press it again.