beautypg.com

Second press (and subsequent) transitions, Hold transitions, Preroll transitions summary – Grass Valley M-2100 User Manual

Page 45

background image

MMCP Installation/Operation Manual

2-21

Transition Controls and Operation

Second Press (and Subsequent) Transitions

During a preroll, a repeat press of the

PreRoll/Transition

button forces the

Preset bus to begin the transition.

First half of Fade transition: Pressing the

PreRoll/Transition

button again

forces the first half of the transition to complete. The Program output is
held in transition matte/silent until the newly transitioned source is
ready to air, and the

PreRoll/Transition

button is released.

Second half of a Fade transition: Completes second half of the Fade.

Mix transition: Pressing the

PreRoll/Transition

button again forces com-

pletion of the transition.

Hold Transitions

During a Fade type transition, you can hold a transition in transition
matte/silent by pressing and not releasing the

Preroll/Transition

button. The

Program bus is set to transition matte/silent and is held there until you
release the button.

Preroll Transitions Summary

Pressing the

PreRoll/Transition

button again after the actual video/audio

transition has started (regardless of how Transition Now is configured) has
the following effects:

For fade-fade (while fading down), cut to matte/silent. Hold in matte
until the

PreRoll/Transition

button is released, switch Preset sources to the

Program bus, then cut the Program bus to on-air.

For fade-take (while fading down), cut to matte/silent. Hold in matte
until the

PreRoll/Transition

button is released, switch Preset sources to the

Program bus, then cut the Program bus to on-air.

For fade-fade and cut-fade (while in fade up mode), immediately set
the Program bus to full gain.

For mix transitions, immediately complete the transfer of Preset
sources to the Program bus at full gain.

If flip/flop operation has been configured as enabled:

For mix transitions, Preset bus output cuts to the previous Program
output when the transition is complete.

For all other transition types, Preset bus output cuts to the previous
Program output as soon as Preset video/audio first appears on
Program output.

Preroll/Transition can affect main audio/video sources and/or AP 2–4
sources delegated for AFA operation. AP 2–4 details are described in the
Installation and Service Manual.