Grass Valley M-2100 - Manual (Page 19)

MMCP Installation/Operation Manual 1-11
Control Panel Cabling
4. In the Boot Configuration screen ( Figure 1-12 on page 1-11 ), enter the
Ethernet IP address for this panel to put it on the MCP Net with the
frames it will be controlling.
5. The Subnet Mask should be 255.255.255.0 (the subnet mask for the
M–2100 network).
6. The Gateway IP should be set to 0.0.0.0.
7. Select Store Changes to Non-Volatile Memory to store these values or Cancel to
make no changes.
Note The MAC address of the Ethernet card inside the panel is also given in read-
only format.
8. Disconnect the panel from the PC and install it onto the MCP Net
Ethernet network.
9. Repeat this procedure on all the MMCP panels to be used with your
M–2100 system, entering unique MCP Net IP addresses (last octet
different) for each MMCP panel.
Figure 1-12. Boot Configuration Screen