Grass Valley M-2100 - Manual (Page 35)

MMCP Installation/Operation Manual 2-11
Program and Preset Bus Operations
If a particular input has been configured as a Router Linked Destination,
the name displayed is one of the following:
■ If SMS7000 communications are active, the name displayed will be the
source name provided by the SMS7000 (in software v5.1 or later).
■ If SMS7000 communications are not active for a set time, the name dis-
played will be *NOLINK*.
■ If the proper SMS7000 destination name has not been entered into Con-
figuration Manager, the name displayed will be *NODEST*.
Non-Sync Source Indicators
Two sets of indicators for non-synchronous sources video (V) and audio
(A) are located at the end of the Program and Preset rows (
Figure 2-4 on
page 2-8 ). The video non-sync indicators display status on the corre-
sponding Program and Preset bus. The two audio non-sync lamps are tied
together. When either bus has an audio non-sync condition, both lights will
indicate non-sync.
Non-sync conditions for audio and video are defined in Table 2-3 .
Note Non-sync backup sources are not reported.
If a Program source goes non-sync, the selected Transition Type button will go
low tally and the Take button will go high tally.
Table 2-3. Non-sync Conditions
AUDIO buttons high tallies
Some aspect of audio for a selected source (primary, breakaway, Over)
on the Program or Preset bus is not in sync.
PGM VIDEO button high tallies
Some aspect of video for a selected source (primary, breakaway) on the
Program bus is not in sync.
PST VIDEO button high tallies
Some aspect of video for a selected source (primary, breakaway) on the
Preset bus is not in sync.