Grass Valley 2000T3 - Manual (Page 38)

38 Kameleon Frames Instruction Manual
Section 3 — Power Up
Applying Power
Upon applying power to the frame, verify that the green power LEDs for
each power supply sled are illuminated. Each power supply sled has a
power LED for each of its supplies (PS 1 and PS 2).
If the frame has a fan module and a 2000NET module installed, check the
red FAULT LED on the front cover. It should go off if the fans are operating
correctly and no other frame faults are detected by the 2000NET module.
Note The Fault LED is on while the 2000NET module is booting. It may take up to
45 seconds to extinguish.
The power supply LEDs may require several seconds to display correct
status after power is applied.
Figure 21. Power Indicator LEDs and Test Pads (2000T3 frame shown)
Other indicator LEDs can be viewed on the optional 2000NET module with
the front cover removed. If you have a 2000NET module installed in the
frame, see the 2000NET Network Interface Module Instruction Manual for
indicator details.
Power Supply
8039-08
PS 1 Green OK LED
PS 2 Voltage test pad
Redundant
Supply
PS 1 Voltage test pad
PS 2 Green OK LED