Grass Valley 2000T3 - Manual (Page 26)

26 Kameleon Frames Instruction Manual
Section 2 — Installation
Rack Mounting the Frame
Use the rear support hardware to help support the weight of the frame.
Refer to
Figure 7 while following these steps to install either the 2000T3 or
2000T1 frame (3 RU 2000T3 frame shown). You will need rack mount
screws to fit the front and rear rack rails.
1. Remove and discard the existing pan-head machine screw on each side
of the frame.
Note The 2000T1 frame uses this screw location (on the power supply side) for
attaching a ground cable. See
Grounding on page 27 .
2. Attach the frame support plates to each side of the 2000 frame using
three 10 mm machine screws (provided) on each side.
3. Secure the rear rack plates to the rack at the appropriate locations using
customer-supplied rack mounting screws.
4. Lift the frame into the rack and slide the frame support plates into the
open slots of the rack plates.
5. Secure the frame front to the equipment rack using four
customer-supplied rack mounting screws.
Figure 7. Frame Support and Rack Mounting (one side shown)
Frame
support
plate
Remove and discard
the existing support
screw
Rear rack plate
10 mm machine
screws provided
8039 -11