Grass Valley 2000T3 - Manual (Page 31)

Kameleon Frames Instruction Manual 31
Module Installation
Front Modules
Figure 13 illustrates a front media module installation.
Figure 13. Typical 2000 Series Front Module Installation
To install a front module in the frame, follow these steps:
1. Hold the module component side up. Insert the left edge of the module
between the left side board edge guides and slide the module into the
frame until the right edge enters the right guides.
2. Verify that the module connector seats properly against the backplane
and the rear module connector.
Note If the rear module is a dual height version, make sure the front module is
inserted in the correct slot to meet the rear connectors.
3. Press the ejector tabs to seat the module in place.
2000
Alignment post and receptacle
8039-16
2000 Frame (front view)
Board edge
guides
Board edge
guides