Grass Valley 2000T3 - Manual (Page 36)

36 Kameleon Frames Instruction Manual
Section 3 — Power Up
Power Connections
The 2000 Series frames and optional redundant power supplies are shipped
with the proper power cords for 120V or 240V operation. Line voltage
selection is not required for this power supply. The power cord connector
type shipped is determined by the shipment’s destination.
For each power supply installed, AC power is fed through a line cord to a
socket (J1 and J2) on the rear of the frame (see
Figure 19 , 2000T3 frame
shown).
Figure 19. AC Power Connectors
Note For the most effective use of redundant power, ensure that each power supply
cord is plugged into a separate branch circuit.
Power,
Frame Configuration,
and Frame Health
Connectors
J 1 0 1
J 2
J 1
J 1 0 3
GND
SER 1
CONFIG
SER 3
GPI
8039-13