Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 - Manual (Page 9)

5
Gateway Commands
Kaleido multiviewers support the following commands through the Gateway access. Most
of these apply to all Kaleido multiviewer models, but some only apply to one platform, as
indicated in the list. Furthermore, there may be differences in the use or syntax of some
commands depending on the platform. All of these points are clarified in the detailed
description of each command that follows.
Index of Gateway Commands
The applicable Kaleido systems are indicated as follows:
The star (  ) symbol indicates a new command, or a command with new parameters.
Note: All gateway commands must be followed by a carriage return. In
scripts, add \n at the end of each gateway command.
Code System Multiviewer Models
KX Kaleido-X Software Kaleido-X, Kaleido-X16, KMV-3901/3911,
Kaleido-XQUAD, Kaleido-IP, Kaleido-MX,
Kaleido-Modular-X
K2 Kaleido-K2 Software Kaleido-K2
AQ Kaleido-Alto/Quad/Quad-Dual Kaleido-Alto, Kaleido-Quad, Kaleido-Quad-Dual
Command Applies to Description Page
openID KX K2 AQ Opens a session with the specified Kaleido 7
closeID KX K2 AQ Closes a previously opened session 8
getParameterInfo KX Gets the system name, or its software version 8
getKCurrentLayout KX K2 AQ Gets the name of the current layout 8
setKCurrentLayout KX K2 AQ Loads a specific layout 9
getKLayoutList KX K2 AQ Gets the list of available layouts 10
getKRoom KX Gets information on how the heads are
positioned within the specified room 10
getKRoomList KX Gets the list of available rooms 11
setKStatusMessage KX K2 AQ Sets a Gateway alarm to the specified state 11
setKUnlatch KX Acknowledges the global alarm for the specified
source (channel) 12
getKChannel KX Gets the source (channel) currently assigned to
the specified monitor 13