Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 - Manual (Page 12)

8
Gateway Commands
closeID
• The system name was invalid.
• The IP address was wrong.
closeID
KX K2 AQ This command closes a session with the specified Kaleido.
• On a Kaleido-X series multiviewer:
• On a Kaleido-K2 or Kaleido-Alto/Quad/Quad-Dual multiviewer:
IP_ADDRESS_0_4_0_0
Where IP_ADDRESS is the IP address of the Kaleido-K2 or Kaleido-Alto/Quad/Quad-
Dual
Gateway response:
• : The command was recognized by the Gateway.
• : The Gateway was not able to recognize the command.
getParameterInfo
KX This command serves two purposes: it can retrieve the current system’s name, or the
version of the Kaleido-X Software installed on this system.
• To obtain the software version, the command is:
get key="softwareVersion"
Gateway response:
• softwareVersion="Software Version"
Example:
softwareVersion="7.20 build 5401"
• : The Gateway was not able to recognize the command.
• To obtain the system name, the command is:
get key="systemName"
Gateway response:
• systemName="System Name"
Example: systemName="Cougar-X"
• : The Gateway was not able to recognize the command.
getKCurrentLayout
KX K2 AQ This command retrieves the name of the current layout.
Note: This command closes the current connection on port 13000. This
connection must be re-established before another session can be opened. If
you are using HyperTerminal, it will automatically re-establish the previous
connection if you begin typing new commands, but other clients may
require you to manually reconnect.