beautypg.com

Opening a gateway session with a multiviewer, Sending commands to the gateway, Closing a gateway session – Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 User Manual

Page 32

background image

28

A Typical Session

Opening a Gateway Session With a Multiviewer

Opening a Gateway Session With a Multiviewer

To open a Gateway session with a multiviewer

1 Enter the

openID

command using the IP address of the multiviewer with which the

connection has to be established.

2 If the Gateway receives the command and recognizes it, it will respond with the

following:

3 If the command cannot be recognized the following message will appear:

The multiviewer is ready to receive commands.

Sending Commands to the Gateway

To send a command

• Type it in the console, and then press the Enter key.

Closing a Gateway Session

To close the Gateway session

1 Enter the

closeID

command, to close the link to the multiviewer.

2 To end the communication session, click the Disconnect button on the toolbar.

This manual is related to the following products: