Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 - Manual (Page 19)

15
Kaleido Remote Control Protocol (Gateway)
User’s Guide
getKMetaData
K2 This command is used to get metadata that is assigned to a MultiData component assigned
to a text label in the Kaleido-K2. The Kaleido-K2 will return XDS, Dolby-E and video format
data in response to this command.
get dataname=MultiDataName
Where MultiDataName is the name of the MultiData source, as defined in the MultiData
Configuration panel.
Gateway response:
• MultiDataName not found : The
MultiData entity does not exist in the Kaleido-K2.
• id="2" stationID="RDS" channelNumber="25"/>
Where the returned information (shown in italics above) is the data contents of the
MultiData element. This example shows a typical return of data; the actual data
returned will depend upon the configuration and definition of the MultiData
component on the Kaleido-K2.
The response is grouped by input, and the inputs sorted in ascending order (from input
1 to 32).
For each input, all the data is presented as attributes.
The data legends is mapped to valid XML attribute names, which are listed here:
• inputFormat
• WSS
• scansys
• AFD
• AFD3Bits
• AFDANC
• SID
• programConfig
• dialogLevel
• networkName
• stationID
• channelNumber
• TSID
• programName
• programType
• vChipRating
• programDescription
• programLength
• elapsedTime
• programID
• timeOfDay