Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 - Manual (Page 27)

23
Kaleido Remote Control Protocol (Gateway)
User’s Guide
setKAudioOutMode
KX K2 AQ
To set the audio monitoring mode at the analog audio monitoring output, the following
command is used:
set mode="XXXXX"
Where XXXXX is the value at which the mode must be set. Valid values are NORMAL, MUTE
and –20 dB.
Gateway response:
• : The command was correctly interpreted. The Audio Monitoring Mode was set
to the specified value.
• : The command was not executed, due to bad spelling or invalid parameter.
The audio monitoring mode remains unchanged.
setKVerticalOffset
AQ This command is used to position the CPU’s graphic output vertically within the final DVI
output on the display. The Kaleido-Alto/Quad’s CPU includes up to 1024 lines, whereas the
final output includes up to 1200 lines.
set offset="NN"
Where NN is the number of lines (between 0 and 175) by which to offset the CPU’s graphic
output, from the top of the final DVI output.
Gateway response:
• : The command was recognized by the Gateway.
• : The Gateway was not able to recognize the command.
setKIcontrolMode
AQ This command is used to enable the Kaleido-Alto/Quad to key the detected mouse pointer
colors on video.
set mode="N"
Where N is either 0 (color not keyed), or 1 (color key enabled).
Gateway response:
• : The command was recognized by the Gateway.
• : The Gateway was not able to recognize the command.
setKMouseColorA
AQ This command is used to set a color to key.
Notes
• To use this command with a Kaleido-X series multiviewer, you must first
open a session with user privilege validation (see openID ), otherwise the
gateway will return .
• The KMV-3901/3911, and Kaleido-IP do not yet support this command.