Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 - Manual (Page 18)

14
Gateway Commands
setKDynamicText
composite42. The monitor name is the name you see (under Assignments in the
Properties tab) when you open the layout in XEdit and select this monitor.
Gateway response:
• : The command was recognized by the Gateway.
• : The Gateway was not able to recognize the command, or a parameter could
not be resolved.
setKDynamicText
KX K2 AQ This command is used to set the text of a UMD or text label component that is configured
to use dynamic text. Note that the Service ID for this component must be set to “Gateway”
when the layout is created in KEdit/XEdit in order for this command to work.
set address="Address" text="NewText"setKDynamicText>
Where:
• Address is the configured text address of the UMD or text label component.
• NewText is the text to display.
Gateway response:
• : The command was recognized by the Gateway.
• : The Gateway was not able to recognize the command.
getKDynamicText
KX This command is used to retrieve dynamic text previously sent to a multiviewer by a
peripheral device (e.g., a router or tally interface device).
set address="Address"
Where Address is the configured text address of the UMD or text label component whose
text you wish to retrieve.
Gateway response:
• RetrievedText
• : The Gateway was not able to recognize the command.
Note: On the Kaleido-K2, to get the monitors’ identifiers for your current
layout press the Tab key on the keyboard, or the select key on the Kaleido-
RCP2.
Note: The Kaleido-Alto/Quad/Quad-Dual systems require a numeric value
in the range 0-1024. The Kaleido-K2 and Kaleido-X series do not have this
limitation.
Note: This command will only return text that was previously set via the
command.