beautypg.com

Getkchannel, Setkchannel – Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 User Manual

Page 17

background image

13

Kaleido Remote Control Protocol (Gateway)

User’s Guide

Example:

set id="my_gateway_alarm_1"

Gateway response:

: The command was recognized by the Gateway.

: The Gateway was not able to recognize the command.

getKChannel

KX

This command is used to obtain the logical source (channel) currently assigned to the
specified monitor in the current layout.

set monitor="MonitorName"

Where

MonitorName

is the name of the monitor whose source you wish to obtain. The

monitor name must be prefixed with the room name and a “/” if the session does not have a
room context. Example: Room1/composite42. To find the monitor name, open the layout in
XEdit (see Name, under Assignments in the Properties tab).

Gateway response:

channelname="ChannelName"

Where

ChannelName

is the full path to the source (channel) currently assigned to the

specified monitor. Example:

/Input A/Channel 1

.

: The Gateway was not able to recognize the command, or a parameter could

not be resolved.

setKChannel

KX K2 AQ

This command is used to assign a logical source (channel) to the specified monitor in the
current layout.

set channelname="ChannelName" monitor="MonitorNumber"

Where:

ChannelName

is the name of the logical source you wish to assign to the specified

monitor. On a Kaleido-X series multiviewer this is the full path to the source (channel).
Example: /Input A/Channel 1.

MonitorNumber

is the identifier of the monitor to which the source is to be assigned.

On a Kaleido-X series multiviewer the monitor number must be prefixed with the room
name and a “/” if the session does not have a room context. Example: Room1/

Note:

Only one parameter can be specified, otherwise the Gateway will

return

.

Note:

This command is currently supported on the Kaleido-IP multiviewer

models only.

This manual is related to the following products: