Setkcurrentlayout – Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 User Manual
Page 13
9
Kaleido Remote Control Protocol (Gateway)
User’s Guide
Gateway response:
• For a Kaleido-Alto/Quad/Quad-Dual multiviewer:
Where
CurrentLayout.xml
is the name of the layout currently loaded to the
monitor wall
• For a Kaleido-K2 or a Kaleido-X series multiviewer:
Where
CurrentLayout.kg2
is the name of the layout currently loaded to the
monitor wall
•
: The Gateway was not able to recognize the command.
setKCurrentLayout
KX K2 AQ
This command loads the specified layout.
• For a Kaleido-K2 or a Kaleido-X series multiviewer:
• For a Kaleido-Alto/Quad/Quad-Dual multiviewer:
Where
LayoutToLoad
is the name of the layout to load.
Gateway response:
•
: The command was recognized by the Gateway, and the layout has been fully
loaded.
•
: The Gateway was not able to recognize the command, or the layout could not
be found.
Note:
On a
Kaleido-X series
multiviewer, the session must have a room
context for the command to be used. If the session was opened using the
command the gateway will return
.
Notes
• This Layout must be available on the multiviewer prior to executing this
command.
• You can use
to retrieve the names of the available layouts
before sending this command.
• For a Kaleido-Alto/Quad/Quad-Dual multiviewer, the layout suffix is
.xml
instead of
.kg2
.
• For a Kaleido-X series multiviewer, if the session does not have a room
context, the layout name must be prefixed with the room name and a “/”.
Example:
setKCurrentLayout>