beautypg.com

Getkactionlist, Setkenablealarmgroup, Setkdisablealarmgroup – Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 User Manual

Page 22

background image

18

Gateway Commands

getKActionList

Where

NameOfTheActionToFire

is the friendly name of the action to be executed.

Gateway response:

: The command was recognized by the Gateway.

: The Gateway was not able to recognize the command, or the command could

not be executed.

getKActionList

KX

This command is used to obtain the list of actions known to your multiviewer system.

Gateway response:

Action1Action2

Action3

: The Gateway was not able to recognize the command.

setKEnableAlarmGroup

KX K2

This command enables the specified alarm group or virtual alarm.

set name="NameOfTheGroupToEnable"

Where

NameOfTheGroupToEnable

is the name of the alarm group (for a Kaleido-K2

multiviewer), or virtual alarm (for a Kaleido-X series multiviewer model) you wish to enable.
In the case of a Kaleido-X series multiviewer model, this parameter can be the

path/

friendlyName

of the virtual alarm, or its URI.

Gateway response:

: The command was recognized by the Gateway.

: The Gateway was not able to recognize the command.

setKDisableAlarmGroup

KX K2

This command is used to disable the specified alarm group or virtual alarm.

set name="NameOfTheGroupToDisable"

Notes

• For a Kaleido-X series multiviewer, the friendly name is specified under the

Properties tab in XEdit.

• The action must be available on the multiviewer in order to be executed.

• On a Kaleido-X series multiviewer, background actions listed in the

On Change/Gateway column under XEdit’s Actions tab will be executed
when the action is fired by the Gateway command.

Note:

On a Kaleido-X series multiviewer, an action that consists of multiple

action items will stop as soon as one of the action items cannot be executed.
The Gateway would then return

.

This manual is related to the following products: