Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 - Manual (Page 16)

12
Gateway Commands
setKUnlatch
set id="ID" status="Status" message="Message"
Where:
• ID is the identifier that will receive the new state.
• Status is any of the available statuses:
• Message is reserved for future use, and is ignored.
Gateway response:
• : The command was recognized by the Gateway.
• : The Gateway was not able to recognize the command.
setKUnlatch
KX This command is used to acknowledge the global alarm for a given logical source (channel).
It can also be used to acknowledge specific alarms.
The command supports three parameter types: channelName , id or uri .
• Use channelName to acknowledge the global alarm associated with the specified
source:
set channelName="ChannelName"
Example:
set channelName="/Input A/Channel 01"
• Use uri to acknowledge the alarm with the specified URI:
set uri="AlarmURI"
Example:
set uri="miranda.monako.daq://local/data/master/3/card/
av1/DTVCCData#dtvccService1Presence"
• Use id to acknowledge the gateway alarm with the specified name:
set id="AlarmName"
Note: Kaleido-Alto/Quad/Quad-Dual will only accept numeric values for
this parameter, in the range 0 to 1024. The Kaleido-K2 and Kaleido-X series
do not have this limitation.
Status Alternate status
a
a. Legacy
Kaleido-X series Kaleido-K2/Alto/Quad/Quad-Dual
DISABLE DISABLE Disabled Disabled
NORMAL OK Normal OK
MINOR WARNING Minor Warning
MAJOR MAJOR Major (not supported)
CRITICAL ERROR Critical Error