Grass Valley K2 Dyno Service Manual - Manual (Page 76)

76 K2 Dyno Replay Controller Service Manual 02 February 2012
Chapter 4 Removing and replacing FRUs
Type II encoder removal
First remove the jog knob and identify your encoder and board type, as in “Control
panel UI board identification” on page 61 . To remove the Type II encoder, continue
by removing the bearing assembly and the top, then work on the top unit separately,
as in the following illustrations.
Identify red ecoder
wire orientation, then
disconnect 1
Red
encoder wire
Remove 4 nuts 2