Grass Valley K2 Dyno Service Manual - Manual (Page 39)

02 February 2012 K2 Dyno Replay Controller Service Manual 39
Using recovery disk images
• You can also start the firmware updater by double-clicking
ControllerUpdater.exe in c:/program files/K2Dyno.
4. Click Update .
• If you click Backup , the current program is backed up to the folder where the
program was installed.
5. Select the update file in the USB memory, and then click Open .
Using recovery disk images
Procedures in this section are as follows:
• “About the recovery disk image process” on page 39
• “Creating a recovery disk image” on page 40
• “Restoring from a system-specific recovery disk image” on page 41
About the recovery disk image process
You can create a disk image of the Dyno controller system drive and restore from the
image. This simplifies the process of rebuilding a system in a disaster-recovery
scenario.
NOTE: This process is not intended as a means to backup and restore media.
When you receive your Dyno controller new from the factory, you a receive a
system-specific disk image for that particular Dyno controller. This factory image is
stored on a bootable USB Recovery Flash Drive. Also on the Recovery Flash Drive
is the Acronis True Image software necessary to create and restore a disk image.
After your Dyno controller is installed, configured, and running in your system
environment, you should create new recovery disk images to capture settings changed
from default. These “first birthday” images are the baseline recovery image for the
Dyno controller in its life in your facility. There is enough disk space on the Recovery
Flash Drive to store the first birthday image along with the factory image.