Grass Valley K2 Dyno Service Manual - Manual (Page 51)

02 February 2012 K2 Dyno Replay Controller Service Manual 51
BIOS startup information
When you exit the diagnostics, both the software and hardware is shut down, and the
K2 Dyno Replay Controller is turned off.
BIOS startup information
The following information appears during a normal startup of the Dyno controller.
This is a part of the BIOS Power On Self Test (POST).
Shutdown/restart problems
If the Dyno controller is inoperable due to a software error it can affect the operation
of the standby button. If pressing the standby button does not shut down the Dyno
controller, press and hold the button for eight seconds. This forces the Dyno controller
to execute a hard power down. If that doesn’t work, disconnect the power cable.
Information Explanation
Phoenix-Award BIOS XX… BIOS and firmware version information
Copyright… Copyright information for the manufacturer of the motherboard.
ECM… Motherboard model information
Memory Frequency… Report of memory currently installed
IDE Channel… Report of system drive
Information Explanation
Pri Master/Slave Disk Enumeration of system drive(s)
Sec Master/Slave Disk
Display Type Report of built-in display (LCD screen)
Serial Ports Report of serial port. (Serial port not used on Dyno)
Parallel Ports NA. No parallel ports present on Dyno.
DDRZ at Bank(s) Report of slot location of memory
PCI Device listing… Report of PCI devices built-in to motherboard