Grass Valley K2 Dyno Service Manual - Manual (Page 44)

44 K2 Dyno Replay Controller Service Manual 02 February 2012
Chapter 2 Service Procedures
14. Select No, I do not and then click Next .
The Restoration Options page opens.
15. Do not change any settings on this page. Click Next .
16. Click Proceed .
The Operation Progress page opens and displays progress.
17. When a “The data was successfully restored” message appears, click OK .
18. Click Operations | Exit to exit the Acronis True Image program.
The Dyno controller restarts automatically.
19. Remove the Recovery Flash Drive while the Dyno controller is shutting down.
20. When restart completes, run C:\WINDOWS\NewSid\NewSid.
21. In the NewSid wizard, do the following:
a. Click Agree .
b. Click Next .
The Choose a SID page opens.
c. Select Random SID and clique Next .
The Rename the Computer page opens.
d. Select the Rename the Computer checkbox and enter the serial number of the K2
Dyno Replay Controller. Then click Next .
e. Click Next to complete the wizard.
f. Restart as prompted.
22. When restart completes, set network settings as follows:
a. For the loopback adapter, verify that the following:
- IP address: 192.168.200.200
- Subnet mask: 255.255.255.0
b. Set NIC names as follows:
- Set rear panel Ethernet port 1 to GB1
- Set rear panel Ethernet port 2 to GB2
23. Install Dyno Client software as instructed in release notes.
When installing software, if prompted to enter the serial number, leave the serial
number field blank. Do not enter the serial number.
Replacing a Dyno controller
To correct some system faults Grass Valley Support sends you a replacement Dyno
controller. Contact Grass Valley Support if you think you need a replacement Dyno
controller.