Grass Valley K2 Dyno Service Manual - Manual (Page 69)

02 February 2012 K2 Dyno Replay Controller Service Manual 69
Top replacement
Top replacement
When replacing the top, install screws in sequence as shown:
T-bar lever assembly removal
To remove the T-bar lever assembly, first remove the T-bar lever handle and the top,
then work on the top unit separately, as illustrated.
1
3
Fasten center screw
to index top unit rear
Fasten center screw
to index top unit front
After top unit is indexed,
fasten remaining screws
2
Remove 4 s crew s .
U s e Torx T-10.
2
Di s connect
cable
1