Grass Valley K2 Dyno Service Manual - Manual (Page 50)

50 K2 Dyno Replay Controller Service Manual 02 February 2012
Chapter 3 Troubleshooting problems
Run hardware diagnostics (software version 1.x)
With the Dyno controller diagnostics, you can check if the hardware is operating
normally as to whether:
• the buttons are illuminated in corresponding colors
• the button brightness can be changed
• the T-Bar position information is correct
• the hardware responds to the JOG operations properly
• the touch panel detects correct positions
• the touch panel brightness can be changed
1. Start up the K2 Dyno Replay Controller.
2. When the Select Session Mode screen appears, press the Fn , Shift , and AddPL
buttons at the same time.
The Diagnostics screen appears.
• You can also start the diagnostics by double-clicking ControllerDiag.exe in
c:/program files/K2Dyno.
3. Perform hardware operation checks.
NOTE: Any changes made in the diagnostics, such as button brightness changes,
will be disabled when you exit the diagnostics.Changes, such as brightness changes
and lever position adjustments, must be made in a calibration.
4. When finished, click the Exit button at the upper right side.