Grass Valley K2 Dyno Service Manual - Manual (Page 35)

02 February 2012 K2 Dyno Replay Controller Service Manual 35
System beep codes
The meanings of the LED states are described in the following table:
If a LAN connector is faulty, you must replace the motherboard.
System beep codes
If there are no errors present the Dyno controller does not emit any audible beeps
during startup process or otherwise. If an error occurs during Power On Self Test
(POST), the BIOS might issue one of the following beep codes:
General specifications
LED LED state Status Condition
Green Green On The adapter is connected to a valid link partner
Green flashing Data activity
Off No link
Green/Yellow/
Orange Off 10 Mbps
Green 100 Mbps
Yellow 10000 Mbps
Orange flashing Identify
Error Beep Code Description
One long and two short beeps A video error has occurred and the BIOS cannot
initialize the video screen to display any additional
information.
A single long beep, repeated. A DRAM error has occurred.
Characteristic Specification
Power AC universal power supply, 100-130 VAC, 200-240 VAC, 50 or
60 Hz. Typical power consumption, 100 watts
Dimensions Dimensions: length = 12.6 in. (316 mm);
width = 8.25 in. (210 mm); height = 7.4 in.(187 mm) (All approx.)
Weight 5 kg (11 lbs.)
Temperature range Operating: 0°C to 40°C (32°F to 104°F); Storage: -20°C to 60°C
(-4°F to 140°F)
Humidity range 10% to 90% (relative humidity)