Grass Valley K2 Dyno Service Manual - Manual (Page 42)

42 K2 Dyno Replay Controller Service Manual 02 February 2012
Chapter 2 Service Procedures
5. On the Welcome page, click Next .
The Archive Selection page opens.
6. In the tree view do one of the following:
• Expand the node for Removable Drive (A:) . This is the Recovery Flash Drive.
Select the image file. The file for the image supplied by the Grass Valley factory
is named with the serial number of the Dyno controller.
• Navigate to the location of the image file from which you are restoring.
An image file has a .tib file name extension.
7. Click Next :
The Restoration Type Selection page opens.
8. Select Restore disks or partitions and then click Next .
The Partition or Disk to Restore page opens.
9. Select FAT32 (C:) and then click Next .
The Restored Partition Location page opens.
10. Select FAT32 (C:) and then click Next .
The Restored Partition Type page opens.
11. Leave the selection at Active and then click Next .
The Restored Partition File System page opens.
12. Select FAT32 and then click Next .
The Restored Partition Size page opens.
13. Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual C: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click
Next .
The Next Selection page opens.
14. Select No, I do not and then click Next .
The Restoration Options page opens.
15. Do not change any settings on this page. Click Next .
16. Click Proceed .
The Operation Progress page opens and displays progress.
17. When a “The data was successfully restored” message appears, click OK .
18. Click Operations | Exit to exit the Acronis True Image program.
The Dyno controller restarts automatically.
19. Remove the Recovery Flash Drive while the Dyno controller is shutting down.