Grass Valley K2 Dyno Service Manual - Manual (Page 38)

38 K2 Dyno Replay Controller Service Manual 02 February 2012
Chapter 2 Service Procedures
can also access the tool by pressing the Shift , Fn , and Next buttons at the same
time.
The calibration screen appears on the LCD screen.
2. Set items as follows:
Upgrading software
When you receive your Dyno controller from Grass Valley, it has all necessary
software installed. For procedures to upgrade software on the Dyno controller, refer
to the K2 Dyno Replay Controller Release Notes for the version to which you are
upgrading. Also refer to K2 Release Notes to upgrade related software on the K2
Summit Production Client.
Updating firmware (software version 2.x)
With software version 2.x or higher, firmware is automatically installed when the K2
Dyno software is installed. If a new board is installed, the K2 Dyno Replay Controller
automatically updates the firmware.
When upgrading Dyno software from version 2.x or higher, the Dyno Replay
Controller automatically checks for updated firmware and upgrades it along with the
software.
Updating firmware (software version 1.x)
1. Copy the update file to a USB memory.
• For instructions on how to obtain the update file, see the latest release notes.
2. Attach the USB memory to the K2 Dyno Replay Controller.
3. As soon as the K2 Dyno Replay Controller starts up, press the Fn , Shift , and A
buttons at the same time.
Touch this… To make this adjustment:
TOUCH PANEL Corrects the touch panel. Touching the panel displays cross-shapes at the upper
left and lower right corners of the screen. Touch them to correct the touch panel,
respectively.
LCD BRIGHT Adjusts the screen brightness. Touch to adjust.
LED BRIGHT Adjusts the button brightness. Touch to adjust.
T-BAR Sets the idle of the T-Bar. Operate the T-Bar to move it to the position you want to
set as 0%, and then touch “0%”. Similarly, touch “100%” at the position to set as
“100%”
JOG Sets the idle of the JOG knob. Touch to adjust. The idle becomes smaller as
you decrease the value.
Load Default Touch to restore the default settings.
Save & Exit Saves the settings and exits the calibration screen.
Exit Discards the settings and exits the calibration screen.