Grass Valley Intuition XG Installation v.5.0 - Manual (Page 56)

Intuition XG Installation & Quick Start Guide 4-5
Quick start instructions
Verifying the installation and setup by previewing the
playout
To verify that the Intuition XG is properly connected and operating, we recommend that you
use the local copy of Xplay to load and playout an asset in the Live window and broadcast
monitor associated with the Intuition XG’s Channel A. For dual channel Intuition XG
devices, we recommend performing the same verification tasks on Channel B.
The following sections provide instructions for verifying the installation and setup of the Intuition XG:
1.
“Verify the Intuition XG’s Output Resolution” on page 4-5
2. “Enable the Intuition XG’s Live window” on page 4-6
3. “Use Xplay to playout a graphic” on page 4-7
Verify the Intuition XG’s Output Resolution
Each of the Intuition XG’s output channels (Channel A and Channel B) have an Output
Resolution setting on their respective Dashboard, which determines the format of the
Intuition XG’s output signal.
To verify (and change) a Intuition XG’s output channel resolution:
1.
In the Intuition XG’s Control Panel for Channel A, select the T OOLS >L AUNCH D ASHBOARD
menu command.
2. Select the device’s channel from the Device List.
If the device is not listed in Dashboard’s Device List, perform a device discovery (see
the Intuition XG Configuration Guide for instructions).
3. Verify the O UTPUT R ESOLUTION setting. If the setting represents your desired output
resolution, continue to the next task.
If the Output Resolution setting is not what you desire, then select a different resolution
from the drop-down list and click the A
PPLY C HANGES button. When prompted, click
Y ES to apply the changes. Click Y ES again to restart the device, which applies the new
setting.