Grass Valley Intuition XG Installation v.5.0 - Manual (Page 52)

Intuition XG Installation & Quick Start Guide 4-1
4 Q
UICK START INSTRUCTIONS
This chapter provides you with instructions for performing the initial setup tasks to get the a
newly installed Intuition XG device up and running. The procedure concludes by verifying
the installation by previewing the playout of an asset in Intuition XG’s Live Window and a
broadcast monitor.
The following table summarizes the tasks that you must perform to quickly start up a factory-
configured Intuition XG device.
Step # Task description
1 Start up the Intuition XG device ( page 4-2 )
• Plug the DVI monitor’s power cable into a power socket and power it on
• Plug the Intuition XG’s power supply cable(s) into a power socket
• Power on the Intuition XG unit
2 Assign a new IP Address for the Intuition XG device ( page 4-4 )
3 Verify the installation by previewing the playout of an asset ( page 4-5 )
• Verify the Intuition XG’s Output Resolution setting
• Enable the Intuition XG’s Live Window
• In Xplay, add an asset to a playlist and verify that it plays out properly
• On a dual channel Intuition XG, repeat the above steps for channel B
4 Complete the quick start procedure ( page 4-8 )
• Disable the Intuition XG’s Live Windows
• Disconnect the keyboard, mouse and DVI monitor