Warning – Grass Valley Intuition XG Installation v.5.0 User Manual
Page 49
3-10
Intuition XG Installation & Quick Start Guide
Installation instructions for the Intuition XG-3U/Dual
To cable the Intuition XG-3U-e or the Intuition XG-Dual-e:
1.
Connect the two (2)
to the power supply sockets on the rear
panel of the Intuition XG chassis.
WARNING
DO NOT plug the power cables into AC power sockets yet.
2.
Connect the
to the USB connectors on the rear panel of the
Intuition XG. Two PS/2 connections are also available on the rear panel, should you
prefer to use another type of keyboard and mouse.
3.
Connect to a monitor to one of the two (2) DVI connectors on the rear panel of
the Intuition XG. If you prefer, you can use the
to connect
the Intuition XG device to VGA monitor.
N
OTE
Although there are two (2) DVI connectors, the Intuition XG can display to only one monitor.
Therefore, it does not matter which of the two connectors the monitor’s cable is connected to.
4.
Connect the Intuition XG device to the Local Area Network (LAN) by connecting
ethernet cables to the two (2) Network Ethernet connectors.
The Intuition XG’s two network ethernet adapters are teamed together (connect 2 cables to
the 2 NIC cards at the same time) to form a third virtual adapter. In the event of an adapter,
cable or switch failure, the network interface fails over to the healthy adapter. See the
Intuition XG Configuration Guide for more details.
If you only have one cable connected, then the teaming is still in effect, but all traffic will be
over that one cable. If that NIC fail, you will have to manually move the cable to the other NIC.
5.
Connect the
to the Intuition XG’s SDI Video card I/O connector.
SDI IN A
Primary SDI program input connection for both single and dual
channel Intuition XG units.
SDI IN B
On dual channel Intuition XG units (XG-Dual-e), the SDI IN B is the
primary SDI program input connection for the second channel.
On single channel Intuition XG units (XG-3U-e), the SDI IN B is not
used.
SDI OUT A
Primary output channel connection for both single and dual channel
Intuition XG units.
For the purposes of this setup procedure, connect this cable to a
broadcast monitor.